Drive Train / Engine
Lever, Throttle
(fits all Triumph and Magnum models) Located on top right handlebar on the both the Triumph and Magnum models. This lever will pulley back on the throttle cable that is connected to the Triumph and Magnum engine.
Pulley, Flat Idler w/ Bushing Triumph
(all Triumph models) This is the Idler Pulley that is next to the Engine on the Triumph.
Pull Starter/Recoil, Triumph (L-SHAPED PINS)
(all Magnum Models) (some Triumph models with Honda Engines***) ***Important when ordering this part to take pull start assembly off of Honda Engine and flip it upright as seen in picture below. Machine sure to engage or pull cord and identify which pins push out. Call Permagreen Supreme Inc. to ensure correct pull start is ordered. Honda Engines could have different pins to engage recoil important to identify which pull start to order.
Spark Plug (Honda Engine)
(Triumph models serial #10501-19230) (all Magnum models) with Honda Engines
Governor Spring (GX 200 Honda Engine)
(Triumph models serial #10501-19230) (all Magnum models) with Honda GX 200 Engines) Slides over governor rod on Honda Gx200 engines to ensure accurate idle.
Pulley,V-Idler w/ Bushing Triumph (Honda)
(Triumph models with Honda Engines***) ***Important this part is only used on Triumph Machines that have the Honda Engines. This part will not work on machines that have VanGuard (Briggs and Stratton Engine)T653711 is the correct part for that machine. This part is assembled with V-pulley and Bushing.
V-Pulley (Honda Engine)
(fits all Triumphs serial # 10501 - 19230) (fits all Magnum models) Honda Engine Pulley is located on shaft coming out of the wet clutch on the Honda engine. Will come with two set screws. Pulley key is not included but can be ordered, part #P651645
Switch, On/Off (Triumph)
(fits all Triumph models) On/Off Switch (or Kill Switch) is used to turn on and off the machine
Dampener Assembly (Triumph)
The Dampener Assembly for the Triumph is located underneath the engine plate that the engine mounts to. It helps support the engine plate and helps absorb the vibration caused by the engine. This will be a singular dampener assembly
Starting Module, Triumph-Honda Only
(fits Triumph models Serial #10501-19230) machines with Honda Engine ONLY This part is part of the wiring harness on the Honda Engine Triumph. Module can only be used on the Triumph with the Honda Engine. The wires connect to the other parts of the harness. This is the main part to the wiring harness.
Pulley, Pump Triumph
(fits all Triumph models) Pump Pulley for the Triumph is located on the shaft of the pump and will come with two set screws.