Frame/Body
Handlebar Grip (Triumph/Magnum)
Replace your old worn out grips to ensure proper control of the machine.
Lever, Throttle
(fits all Triumph and Magnum models) Located on top right handlebar on the both the Triumph and Magnum models. This lever will pulley back on the throttle cable that is connected to the Triumph and Magnum engine.
Knob, Fert Rate Kit
(all Triumph models) This knob upgrade kit had a new and improved know that can be locked in place by a nylon locknut. This kit includes the following parts: 1 qty T422937 New, Knob Fert Rate 1 qty T645945 1/4-20 Zinc Locknut 1 qty T645940 1/4-20x1-1/4 Zinc Carriage Bolt Instructions for this kit, give illustrations of how to install new knob.
Spinner Gearbox Hood Bearing (Triumph)
This bearing goes over the shaft coming up from the Triumph Spinner Gearbox that comes up through hole in the middle of the green plastic hood piece.
Sulky, Foot Pads
(fits all Triumph models) **FOOT PADS ARE NOW ORANGE/BLACK** Foot pads are located on the sulky. Self stick foot pads ensure operator safety while on the machine. Anti-fatigue mat provides comfort for operator feet while operating machine.
Lever, Brake/Spray Triumph
(all Triumph models) Brake/Spray Lever is the plastic black levers used on both front and rear brakes, along with the spray lever located on both sides of handlebars. Old part is #T654140.
Upgrade Foot Pad Kit
(fits all Triumph models) NEW Thicker pads Foot pads are located on the sulky. Self stick foot pads ensure operator safety while on the machine. Anti-fatigue mat provides comfort for operator feet while operating machine. Kit includes instructions and flat blade to remove old Foot Pads.
Shaker Striker
(Triumph models Serial #14151-present) Used on block set T651969 to strike plate on hood.
Nut, Square Nylon
(fits all Magnum models)(fits all Triumph models) This part is used for attaching body panels to machines in various places.
Triumph Hood (fits Triumph models Serial #10501-14150)
(fits Triumph models Serial #10501-14150) Hood NO LONGER attaches with hardware.
Screw, 1" w/Sealing Washer
(fits all Magnum models) Screws w/Sealing Washer is used to fasten down the green hood pieces on the Magnum
Clip, Push on Retaining 1/2 Triumph
(fits all Triumph models) This push on retainer is located on the left hand side of the bottom of the fertilizer lever. It helps hold the fertilizer lever and deflector lever securely onto the handlebar housing.