Hardware
Rod End, Hardened Female
(all Triumph models) (all Magnum models) This part is located between the sulky and frame. On triumph this part is attached to a male rod end (T652663) is a part of the articulation of the sulky. This part is a hardened rod end. Replaces old part #R652462.
Washer, Sleeve Bearing Thrust
(fits all Triumph models) Used on Idle Pulley arm.
Stud, B
(fits Triumph models Serial #12657-16999) Stud is used on sulky to attach female rod end on sulky.
Spring, Handle Recoil
Triumph Drop Down Handle Recoil Spring
Washer, Nylon Shoulder #8
(fits all Magnum models)(fits all Triumph models) This part is assembled on the shut-off plate in the hopper.
Clamp, Shut Off Plate
(fits all Magnum models) (fits all Triumph models) This clamp holes third hole cable to the shutoff plate.
SlidePlate Tension UpGrade KIT
(all Triumph models) This kit provides hardware to mount Slide Plate located underneath the hopper. This kit includes the following parts: 2 qty P422925 Screw, Slide Plate 2 qty P645220 Counter Sink Washer, #10 2 qty P645225 Nylon Washer, #10 2 qty P645230 Urethane Washer, #10 This kit is only to mount Slide Plate. More hardware is available to mount other components to underneath hopper. Please check you parts manual for other part numbers.
#5 Worm Clamp
(fits all Triumph models) (fits Magnum models with updated spinner platter) This worm clamp is located at bottom of the spreader impeller and helps secure the impeller around the spinner shaft.